Hot Tub pH Increaser: 6 Picks Compared by Dose per 100 Gallons

The best hot tub pH increaser for most spa owners is SpaGuard pH Increaser: it is 100% sodium carbonate, its label gives a dose for each starting pH (1 teaspoon per 100 gallons at pH 7.2), and it shows 4.8/5 from 5,600+ Amazon ratings. If your total alkalinity is also low, pick a sodium bicarbonate product such as Leisure Time Spa Up instead, because it raises both readings at once.

Nearly every spa pH increaser is one of two chemicals. Sodium carbonate (soda ash) moves pH quickly and changes total alkalinity only a little. Sodium bicarbonate (baking soda) raises alkalinity and pushes pH up more gently. This page sorts six products by that difference and converts each label dose to teaspoons per 100 gallons, so you can compare them against your tub’s size.

We may earn a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.

How we chose

We did not lab-test these products. We compared manufacturer labels and dosage charts, the active ingredient listed by the maker or retailer, and the Amazon listings (rating and rating count as shown on November 20, 2026, plus Amazon’s review summaries where available). Every product is sold for spas and hot tubs, in containers of 2 lb or less, because a 10 lb pool bucket of soda ash will clump long before a 400-gallon tub uses it up.

Quick comparison

Product Form / size Active ingredient Label dose at pH 7.2, per 100 gal Amazon rating (Nov 2026)
SpaGuard pH Increaser Granular, 1.12 lb (18 oz) Sodium carbonate 100% 1 tsp (max 1 oz per 500 gal at once) 4.8/5, 5,600+ ratings
HTH Spa pH Up Granular, 2 lb Sodium carbonate 99% 1 tsp (chart: 2 tsp per 200 gal) 4.7/5, 1,000+ ratings
Clorox Pool&Spa Spa pH Up Granular, 18 oz Sodium carbonate 0.5 to 2 tsp (label range: 1 to 4 tsp per 200 gal) 4.7/5, 3,286 ratings
FROG JumpH Granular, 2 lb, measuring cap Sodium carbonate Bottle chart; retailer rule of thumb 1 tbsp per 500 gal per 0.1 pH 4.7/5, 174 ratings
Leisure Time Spa Up Granular, 2 lb Sodium bicarbonate 100% About 1.2 tsp (1 oz / 2 tbsp per 500 gal at pH 6.8 to 7.2) Rating not shown
AquaDoc Spa pH Increaser Liquid, 32 oz Sodium carbonate (liquid) Not on the Amazon listing; one retailer lists 1 oz per 500 gal 4.5/5, 781 ratings

Soda ash or baking soda: test alkalinity before you buy

The choice depends on your total alkalinity (TA) reading, not on brand. FROG and HTH both tell owners to get TA into 80 to 120 ppm before adjusting pH, because TA is the buffer that holds pH in place. Our guide to hot tub test strips covers kits that read both numbers.

  • pH low, TA in range (80 to 120 ppm): use a sodium carbonate pH increaser (SpaGuard, HTH, Clorox, FROG). It moves pH without pushing TA much higher.
  • pH low and TA low: fix TA first with sodium bicarbonate. Leisure Time Spa Up does both jobs, or see our alkalinity increaser comparison. Retest pH after TA settles, since it often rises with it.
  • pH low, TA high: a pH increaser will push TA higher still. This is where repeated small doses and a retest matter most; adding baking soda here makes it worse.

Hot Tub Warehouse’s notes on Leisure Time Spa Up state the same logic: sodium bicarbonate raises both pH and alkalinity, so if only pH is low, a sodium carbonate product is the better fit.

Why the target is 7.2 to 7.8

The CDC recommends a hot tub pH of 7.2 to 7.8 in its disinfection guidance (its newer consumer pages list 7.0 to 7.8). Below 7.0, the CDC notes, chlorine kills germs faster but pipes are more likely to corrode, and bathers get eye and skin irritation. Above 8.0, chlorine works poorly. Manufacturer labels aim a little tighter: SpaGuard targets 7.2 to 7.6, FROG 7.2 to 7.6 on its product page, and Leisure Time and HTH 7.2 to 7.8.

Overshooting is the common mistake. HTH’s pool pH Up label warns that going above 7.8 can cause cloudy water and scale, and Amazon’s review summary for SpaGuard notes several owners reporting cloudy water after dosing. Small doses and a retest after 30 minutes avoid both.

SpaGuard pH Increaser: best overall

SpaGuard’s chart is the most granular of the group: half a teaspoon per 100 gallons at pH 7.3, 1 teaspoon at 7.2, 2 teaspoons below 7.2, and nothing at 7.4 or above. The label caps a single addition at 1 oz per 500 gallons. Add it with the pump on high, run for 30 minutes, then retest.

Who it’s for: owners whose TA is already in range and who want a chart they can read without math. Skip it if: your TA is low too, since sodium carbonate does little for it.

  • Pro: 100% sodium carbonate, per the retailer ingredient listings
  • Pro: dose chart from 100 to 400 gallons by starting pH
  • Pro: highest rating count of this group (4.8/5, 5,600+ ratings on the listing family)
  • Pro: Amazon’s review summary says owners find it easy to use and say it raises pH without residue
  • Con: the same summary reports mixed comments on water color, with some owners seeing cloudy water
  • Con: 18 oz is the smallest container here; a 3-pack is sold separately

Check price on Amazon

HTH Spa pH Up: most product per container

HTH publishes a full chart for 200, 400 and 800 gallons, which helps owners of larger spas who would otherwise scale up a 100-gallon figure. At pH 7.2 it calls for 2 teaspoons per 200 gallons, the same rate as SpaGuard. HTH says to add it through the filter skimmer with circulation running, wait 30 minutes and retest, and not to mix it with other chemicals.

Who it’s for: 400 to 800 gallon tubs and owners who adjust pH often. Skip it if: you only make one or two corrections a season and won’t use 2 lb before it absorbs moisture.

  • Pro: 2 lb container, versus 18 oz for SpaGuard and Clorox
  • Pro: chart covers up to 800 gallons
  • Pro: listed as compatible with bromine, chlorine and biguanide spas
  • Con: the Amazon listing calls the pH range “7.2 and 7.8 ppm”; pH has no unit, which shows the listing copy wasn’t checked carefully
  • Con: “mineral crystals” on the listing is marketing copy; the maker’s ingredient panel lists sodium carbonate 99%

Check price on Amazon

Clorox Pool&Spa Spa pH Up: small tubs and tight budgets

The listing title gives the dose as 1 to 4 teaspoons per 200 gallons, which works out to 0.5 to 2 teaspoons per 100 gallons, the same spread as SpaGuard’s chart from pH 7.3 down to below 7.2. Clorox’s spa product page lists a 7.2 to 7.6 target.

Who it’s for: 200 to 300 gallon tubs, inflatables and occasional corrections. Skip it if: you want a per-pH chart on the listing; the Amazon page only gives the range.

  • Pro: 4.7/5 from 3,286 ratings
  • Pro: Amazon’s summary says owners find it easy to use with good instructions
  • Pro: sodium carbonate, so it won’t push TA up much
  • Con: the same summary says some owners find it takes a lot of product to make a large change
  • Con: the Amazon details field lists the form as “Liquid” while the title says granular, so check the container when it arrives

Check price on Amazon

FROG JumpH: easiest to measure

JumpH ships with FROG’s TruDose cap, which has cup and tablespoon marks, and a dosage chart on the bottle for hot tubs and swim spas. FROG’s directions: confirm TA is 80 to 120 ppm, add with the jets on and nobody in the tub, run the jets 30 minutes with the cover off, retest after 2 hours. One retailer summarizes the chart as about 1 tablespoon per 500 gallons for each 0.1 rise in pH; FROG itself points to the bottle chart.

Who it’s for: FROG @ease or mineral-system owners, swim spas, and anyone who loses track of teaspoons. Skip it if: you want the largest rating history; this ASIN shows 174 ratings.

  • Pro: measuring cap built into the bottle
  • Pro: dose guide covers swim spas as well as hot tubs
  • Pro: listed as compatible with chlorine, bromine and salt systems
  • Con: a 2-hour wait before retesting, versus 30 minutes on the SpaGuard and HTH labels
  • Con: newer listing with a much smaller rating pool

Check price on Amazon

Leisure Time Spa Up: when alkalinity is low too

Spa Up is 100% sodium bicarbonate, so it is closer to an alkalinity increaser than the other five. Leisure Time’s dose is 1 oz (2 tablespoons) per 500 gallons when pH is 6.8 to 7.2, and 2 oz below 6.8. Retailers print two versions of the directions: one says retest after 30 minutes, the other says circulate 1 to 3 hours and retest after 3 hours. Waiting longer is the safer reading, because bicarbonate also moves TA.

Who it’s for: fresh fills or tubs where pH and TA test low together. Skip it if: your TA is already 120 ppm or higher.

  • Pro: raises pH and TA in one product
  • Pro: listed as compatible with chlorine, bromine, ozone and biguanide
  • Pro: 2 lb container
  • Con: slower and weaker on pH alone than sodium carbonate
  • Con: conflicting retest times across retailer copies of the label; the Amazon rating was not shown when we checked

Check price on Amazon

AquaDoc Spa pH Increaser: the liquid option

AquaDoc sells a sodium carbonate liquid in a 32 oz bottle. A liquid pours without dust and doesn’t clump in a humid shed. The catch is dosing: the Amazon listing tells you to add it “to adjust the pH levels” without an amount, and one retailer lists 1 oz per 500 gallons, so read the bottle before the first dose.

Who it’s for: owners who dislike handling powders. Skip it if: you want a clear chart before you buy.

  • Pro: liquid, no measuring spoon or undissolved granules
  • Pro: 4.5/5 from 781 ratings; Amazon’s summary says owners find it easy to use
  • Con: the same summary reports mixed results on effectiveness and value
  • Con: no dose stated on the Amazon listing

Check price on Amazon

How to dose a pH increaser without overshooting

  1. Test TA and pH. Correct TA first if it is under 80 ppm.
  2. Work out your volume in gallons from the owner’s manual, then take the dose for your starting pH from the label.
  3. Start at the lower dose. For sodium carbonate at pH 7.2, that is about 1 teaspoon per 100 gallons on the SpaGuard and HTH charts.
  4. Add with circulation running and nobody in the tub. SpaGuard says pump on high; HTH says through the skimmer.
  5. Retest after the label’s wait (30 minutes for SpaGuard and HTH, 2 hours for FROG). Repeat if still under 7.2.

If pH keeps falling within days, check TA again before buying more increaser. A very low TA reading lets pH drift. Shock treatments also change water balance, which our hot tub shock comparison covers.

FAQ

Can I use baking soda as a hot tub pH increaser?

Baking soda is sodium bicarbonate, the same active ingredient as Leisure Time Spa Up. It raises TA and pH. If only pH is low and TA is in range, a sodium carbonate product is the better match.

How much pH increaser do I add to a 400-gallon hot tub?

On the SpaGuard chart: 2 tsp at pH 7.3, 4 tsp at 7.2, 6 tsp below 7.2. HTH’s chart gives the same 2, 4 and 6 tsp for 400 gallons. Other brands differ, so use your bottle’s chart.

How long after adding pH increaser can I use the hot tub?

The labels say to circulate for 30 minutes (SpaGuard, HTH) or 2 hours (FROG) and retest. Get in once pH reads 7.2 or above and your sanitizer is in range.

Why does my hot tub pH keep dropping?

Low TA is the usual cause, which is why FROG and HTH tell owners to fix TA before pH. Test TA first; if it is below 80 ppm, raise it before adding more pH increaser.

If you remember one rule: pH low with TA in range calls for sodium carbonate (SpaGuard, HTH, Clorox, FROG, AquaDoc); pH and TA both low call for sodium bicarbonate (Leisure Time Spa Up).

Sources

Checked November 20, 2026.

  • CDC, Disinfection & Testing (pH 7.2 to 7.8): cdc.gov
  • CDC, Home Pool and Hot Tub Water Treatment and Testing (pH 7.0 to 7.8, effects of high and low pH): cdc.gov
  • SpaGuard pH Increaser dose chart, 1 oz per 500 gal limit, sodium carbonate 100%: spaandpoolstore.com, poolsupplymall.com
  • HTH Spa pH Up chart, directions, ingredients: hthpools.com; HTH pool pH Up (cloudy water above 7.8): hthpools.com
  • Clorox Spa pH Up target range: cloroxpool.com
  • FROG JumpH directions: frogproducts.com; retailer dose summary: pstpoolsupplies.com
  • Leisure Time Spa Up dose and ingredient: poolgeek.com, spacare.com, hottubwarehouse.com
  • AquaDoc retailer dose: thesummerpools.com
  • Amazon listings (features, ratings, review summaries, Creators API and listing pages, Nov 20, 2026): ASIN B01BF8DYKI and B01M1HKGU8 (SpaGuard), B09RFZGKC3 (HTH), B00PZZFVFE (Clorox), B0FLRKLMXD (FROG), B000V89QRY (Leisure Time), B09SQ9BS7J (AquaDoc)
  • Featured image: Pexels photo 14436987